Voice over odrial interface | Telit Cinterion IoT Developer Community

September 10, 2014 - 6:50pm, 2744 views

Modules

Is there any possibility to transfer voice over serial line? after connection play a voice message. What module do you recommend? Thank you Marek Zeman

skype marazeman

Comment

Jędrzej Gemalto...

Sep 10 2014 - 8:26pm

Hello, you can use AGS2-E. It's automotive module supporting voice prompts. It allows you to record a message on module's FFS or download it using flash handling commands. Then you can play the message to near end (module's speaker) or far end (remote side). Regards Jedrzej

Like
2
Log in or register to post comments

mzeman

Sep 11 2014 - 8:03pm

Hello Jedrzej, thank you for the hint. I checked AGS2 documentation. Do I understand correcttly that there could be saved more voiceprompts, every up to 64kB, in FFS? And there is played a prompt that is loaded to RAM. Is it correct? What is FFS size? Best regards Marek

skype marazeman

Like
0
Log in or register to post comments

Jędrzej Gemalto...

Sep 12 2014 - 2:30pm

Hi, AGS2-E has 1 966 080 bytes of internal flash storage. Every voiceprompt file must have maximum size of 64kB which is about 40 seconds in highest quality and 107 seconds in lowest quality. Please don't mix AGS2 with AGS2-E. These are different products. AGS2-E provides more flexible voice prompts handling (AGS2 plays only local voiceprompt). Check the note http://m2m.gemalto.com/products/automotive/lga/ags2-e.html For more documentation please contact your distributor. Regards Jedrzej

Like
0
Log in or register to post comments

You are here

Voice over odrial interface | Telit Cinterion IoT Developer Community