USB Host Driver and other interfaces drivers for Cinterion ALS3-US Wireless Module | Telit Cinterion IoT Developer Community
July 28, 2015 - 6:53am, 5142 views
Hi,
Could anyone of you direct me to the place where I can get the USB host driver (for Linux) for
Cinterion® ALS3-US Wireless Module:
http://m2m.gemalto.com/tl_files/cinterion/downloads/datasheets/gemalto_d...
Host Drivers (in Linux) for the following interfaces would be useful too:
>> Digital audio interfaces (PCM or I2S)
>> USB 2.0 HS interface up to 480 Mbps (mentioned above)
>> UICC and U/SIM card interface 1.8 V and 3 V
>> Serial Interface (UART)
>> 10 GPIOs shared with Network Status and Low Current Indication, 2 ADC’s
Thanks in advance.
Hello,
You don' need any special driver for Linux.
ALS3 module features a standard CDC/ECM interface. It uses the driver which is in the Linux kernel.
The USB port is CDC-ACM and you will see the ports under /dev/ttyACM*
You may also find some useful information under this link:
https://iot-developer.thalesgroup.com/tutorial/ph8phs8-pvs8-pxs8-fw-upgr...
Regards,
Bartłomiej
Hi,
I am looking for USB drivers for the same device but for Windows 7 64bit. Can you tell me where I find them?
Kind regards,
Colin.
Hello Colin,
Please check your email.
Best regards,
Bartłomiej