Reset EHS8 | Telit Cinterion IoT Developer Community
April 15, 2020 - 5:09pm, 1905 views
I changed the configuration of AT ^ SGPSC = "Nmea / Interface" to "asc0" and I can no longer send at commands to the board or change this setting to "local". I would like to know how to reset the EHS8 card, clearing all settings, as the card now does not respond to any commands
Hello,
You can change the setting from some other interface: ASC1 (if enabled in the configuration) or USB.
Regards,
Bartłomiej
I don't have an ascI interface, I always sent data via the asc0 interface via AT ^ commands. I can't do a hard reset manually on the board? and using USB, can I use at pure commands to send command to board? if so, which library should I add in order to use pure commands. Thank you!
Hello,
There's no hard reset possible. You can send AT commands on USB in the same way as on RS232. There are few USB intefaces that enumerate in the system on a single physical line. Please note that not all of them can accept AT commands. See ^SCFG: "Serial/Interface/Allocation" configuration. As for the library I don't know your system so I can't help. In case of linux USB should work without any additional drivers (at least if kernel is not very old).
Regards,
Bartłomiej
Thank you!!!