Pull-down resistor for ignition line | Telit Cinterion IoT Developer Community
December 16, 2015 - 11:02am, 2289 views
Hello,
I have looked at the documentation and I only see mention of pull-down resistors for the GPIO lines. I would like to confirm if the ignition and reset lines also need pull-down resistors.
Thank you.
Hi,
Ignition and reset does not need a pull-down resistors, these resistors are built in the module. Depending on the module which you are using you should be able to find this information mentioned in some way. E.g. for BGS5 it is in hd description manual in chpt. 2.1.14.4.
Best regards,
Michał