Thales' cellular IoT products business is now part of Telit Cinterion, find out more.

You are here

Community > Forum > Cellular Hardware > Problems switching on BGS5 Using ON Signal

Problems switching on BGS5 Using ON Signal | Telit Cinterion IoT Developer Community

Like
0
1
ldepinto's picture
ldepinto

September 9, 2016 - 10:44am, 1429 views

Hi everybody,

We have this schematic to switch on a BGS5 module but it's not working

Something strange for you? Is there any value that I should change?

The same configuration was working in a previous prototipe but the new prototipes don't switch on.

Thank you

1
Comment
Log in or register to post comments
Bartłomiej Gemalto Moderator's picture
Bartłomiej Gema...
Sep 9 2016 - 3:40pm

Hello,

Please see this link https://iot-developer.thalesgroup.com/documentation/hardware-bgs1-bgs2bg... to compare with the reference design. Also in the hardware description for the module there are different scenarios for switching on the module described. 

Please also make sure if you don't have a "back powering issue"​ - if there is no power on any pins while the module is switched off.

Regards,

Bartłomiej