PLS8-X : AT+SAD and RX Diversity | Telit Cinterion IoT Developer Community
September 18, 2017 - 10:53am, 2239 views
Hello,
Diversity module of our PLS8-X modules is active by default, so we let factory default with AT+SAD=11.
We do not connect any diversity antenna to the module, but we've let the default SAD=11 : are there any bad consequences for signal strenght, module consumption, or general module behaviour, because of this ?
Thanks a lot,
Have a great day.
Vincent.
Hello,
There should not be any harm from leaving this default setting.
The power consumption is not specified separately for antenna diversity on and off.
If your application does not use this it could of course be switched off.
Best regards,
Bartłomiej
Hello,
Thanks !