Gemalto is now part of the Thales Group, find out more.

You are here

PLS8-E in factory test mode | Thales IoT Developer Community

February 8, 2017 - 2:41pm, 2526 views

Hello,

I'm developing an application with a PLS8 module. For this a PLS8-E on a dev kit using the DSB75 adapter is used. 

Somehow the functionality level of the module after power-on is reported "SYSSTART FACTORY TEST ****". The AT+CFUN? command also reports the undocumented status 5:

AT+CFUN?

+CFUN: 5

In this **** the data connection to my provider is usually rejected. After changing to normal operation **** the data connection is accepted (After doing AT+CFUN=1).

Is this normal behavior? Or is there a way to make it start in normal ****?

Thank you.