PLS8 Cannot get network | Telit Cinterion IoT Developer Community
May 2, 2017 - 10:39am, 2988 views
HI,
Could anyone please help to check the board setting in the attached photo? I can use com port to read/write AT command, however, it cannot get network and service provider, could you please advise?
Thanks.
Best regards,
Alice
Can you post the AT commands log you run into trouble so that others can see what's wrong with your setup?
Best Regards,
Antony Shen
Hi Antony,
I am using AT^SIND? and AT+CREG? to check the netowrk status. The module can read the CCID of sim card. Any AT commadns I need to set in order to set up the network?
Thanks.
Alice
Hi Alice,
Which SIM holder are you using? The one(s) on the DSB or the one on the adapter board?
The adapter board SIM connector is the right one.
Your main antenna connection is right. If you are not using the diversity/MIMO antenna, please
enter AT^SAD=10 to disable that antenna connection. AT^SAD=11 will return it.
Best Regards,
Antero
Antero Markkula
Communication and Mechatronics
Enkom Active Oy – www.enkom-active.fi
Upseerinkatu 3 A, 02600 Espoo, Finland
Mobile: +358 400 411368
Office: +358 10 204 0000
Fax: +358 10 204 0010
E-mail: antero.markkula@enkom-active.fi
Hi Antero,
I am using adater one. I have set the AT^SAD=10 but it still cannot connect to network by reading CREG and SIND. Below are the result:
AT^SAD=10
^SAD: 10
OK
AT+CREG?
+CREG: 0,0
OK
AT^SIND?
^SIND: signal,0,99
^SIND: service,0,0
^SIND: sounder,0,0
^SIND: message,0,0
^SIND: call,0,0
^SIND: roam,0,0
^SIND: smsfull,0,0
^SIND: audio,0,0
^SIND: simstatus,0,5
^SIND: simdata,0
^SIND: eons,0,0,"","",0
^SIND: nitz,0,"",+00
^SIND: sendsms,0,0,0
^SIND: psinfo,0,0
^SIND: simlocal,0,1,0
^SIND: lsta,0,0
^SIND: pacsp,0,99
^SIND: steerroam,0
^SIND: pagingcoor,0,0
^SIND: ceer,0,0
^SIND: iccid,0,"89852061511244139747"
^SIND: euiccid,0,""
^SIND: imsi,0,"454065400256974"
^SIND: is_cert,0,0,"","","","","",""
^SIND: newsms,0
^SIND: voiceprompt,0,0
^SIND: ltebot,0,0,0,""
^SIND: simread,0,0
Please advise.
Thanks.
Best Regards,
Alice
Hello,
Could you also provide AT^SCFG?, AT^SMONI, AT+COPS?, AT+CGDCONT?, AT+CREG? outputs?
Regards,
Bartłomiej
Hi Bartłomiej,
The problem is solved.
Thanks for your help.
Regards,
Alice
Great!
Could you possibly describe what the proble was? Maybe someone else will face the same thing.
Thanks,
Bartłomiej