PHS8-P full factory reset | Telit Cinterion IoT Developer Community
May 8, 2015 - 10:43am, 3328 views
Hi!
Is it possible to make full factory reset without ASC0 or USB interface?
Perhaps it ***** to connect some pins of the module?
We need to reset baudrate ASC0 to 115200.
Version of the module is: 3.001.
Thanks!
HI,
It's is not posible.
you need to send at&F over RS232 or USB to reset the most of the commands to factory reset, some other commands like at^sdport has to be handled manually
Regards
Trasto
What if you load midlet over the air which would issue AT command that you need? Then you don't need to plug cable to issue command. I don't know if PHS8 supports that I know that BGS5T does.
Regards,
Jure
Hello,
It is not possble to do factory reset with any module's pins.
Regards,
Bartłomiej