JRC for EHS6, REINSTALL FW | Telit Cinterion IoT Developer Community
April 10, 2019 - 10:16pm, 2001 views
Hello,
I have module EHS6 REVISION 02.000 wihtout JRC.
^SYSLOADING
^SYSINFO: 200
AT^SJAM=4
OK
Please, I need JRC-1.50.9 for install it.
Regards!
Hello,
It seems that there is no JRC on the first module. I'll send it to you. You can install it jus as any other MIDlet. The gWinSwup application that installs the firmware can also do it.
Best regards,
Bartłomiej
Hello,
Thank you for your help!
I installed the JRC just as any other MIDlet and the module was updated successfully. However, theses parameters are not configured:
^SCFG: "Call/Ecall/AckTimeout","5000"
^SCFG: "Call/Ecall/Callback","0"
^SCFG: "Call/Ecall/CallbackTimeout","43200000"
^SCFG: "Call/Ecall/Msd","0000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000"
^SCFG: "Call/Ecall/Pullmode","0"
^SCFG: "Call/Ecall/SessionTimeout","20000"
^SCFG: "Call/Ecall/StartTimeout","5000"
^SCFG: "MEopMode/Dormancy","0","0"
Module A Response:
AT^SCFG="Call/Ecall/AckTimeout","5000"
ERROR
AT^SCFG="Call/Ecall/Callback","0"
ERROR
Module B Response:
AT^SCFG="Call/Ecall/AckTimeout","5000"
^SCFG: "Call/Ecall/AckTimeout","5000"
OK
AT^SCFG="Call/Ecall/Callback","0"
^SCFG: "Call/Ecall/Callback","0"
OK
How i can set the parameters?
Regards!
Hello,
These parameters are related to eCall support only. Are you going to use eCall with these modules?
Were these parameters available before on this module?
I seems that one of these modules does not support eCall.
Best regards,
Bartłomiej