Gemalto EHS6 communication and init problems | Telit Cinterion IoT Developer Community
February 23, 2017 - 11:52am, 1387 views
Hi
Can anyone here help me to configure my Gemalto EHS6 to simply communicate simular with the existing MC66 from MC Techonoligies. I know they have the same AT commando set, but I thing there is a problem with the system configuration of the Gemalto EHS6 ( Jawa machine etc ). I want it to communicate only with Rx and Tx, no HW handshake etc. Is there a easy way to initialize the the EHS6 to simple communication on COM 1, or do I have to do it by AT commands step by step etc.
Another question : Anybody here know if the Gemalto EHS6 is approved to the Japanese marked?
Hope anyone can help me here.
Looking forward to hear from you
Hello,
The AT commands set is similar but there may be some slight differences so I think that you need to test it. Java VM on EHS6 should not be a problem here since you will not be using it (at least in a stright way). EHS6 uses HW flow control by default so you will probably have to disable it with AT command.
Are you going to use the terminal EHS6T or just a module with some other hardware? In case of terminal you may need to leave the HW flow control configured and connect RTS with CTS on the terminal.
I've seen some Jate Telec documents for Japan but I'd need to verify the Japanese approval. Anyway you should get the information and necessary documents from your local Gemalto sales.
Regards,
Bartłomiej
Hello,
Could you also write what kind of SIM card and operator you are going to use?
Regards,
Bartłomiej