ELS61-E is dead after Java-SDK installation | Telit Cinterion IoT Developer Community
July 27, 2017 - 4:33pm, 5973 views
First step. I installed the Gemalto USB-driver and I was able to send some AT-commands via USB. Ping via cellular network worked good too. All right. Second step. I installed the Gemalto SDK (els61-us_e_rev01.000_arn0001400_install-cd). The installation routine said, that no RAS-connection (to debug) found. Now I can't get any USB connection. Via serial port comes every 5 seconds: ^SYSLOADING. Short time after restart (0.5 sec) I can put the AT-command. Here are the the responds for "ati" and "at^scfg?" I tried the same procedure with a second ELS61-E. The same mistake. What is wrong? How can I make the "Hardreset" of ELS61-E?
With best regards
Alexey.
Hello Alexey,
It will not work in this firmware version. This problem that was causing this behavior has already been identified and fixed. But the firmware which contains the fix is not yet available as public release.
Best regards,
Bartłomiej
Hello Bartłomiej,
would you please give me to know, if the new firmware is released.
With best regards
Alexey.
Hello,
Currently there is A-REVISION 00.026.00 available but this version does not contain the fix yet.
Regards,
Bartłomiej