EHS6T stops responding | Thales IoT Developer Community
December 10, 2014 - 2:54pm, 2085 views
I am attempting to drive the EHS6T via HyperTerminal.
On power-up I get the message:
I can issue AT commands initially, ie AT+COPS?
These are echoed back from the EHS6T and viewable on HyperTerminal (local Echo is OFF).
And I get the expected reply, with OK from the EHS6T.
The above suggests basic communications are OK.
However after about 5 secs The EHS6T stops responding – no characters are echoed back to HyperTerminal in response to inputted commands.
If I power down / up the above process can be repeated.
Any clues to keep the EHS6T operational ??