Does AT^SCFG="Gpio/mode/SYNC", “std“ require reboot on EHS5/EHS6? | Telit Cinterion IoT Developer Community
April 20, 2020 - 4:48pm, 718 views
Tried to set AT^SLED=2,50 after AT^SCFG="Gpio/****/SYNC", “std“ fails with error, unless device is rebooted.
Can anyone confirm? If so, is it documented anywhere?
What is the default AT^SCFG factory configuration?
Thanks.
Hello,
Yes the hardware configuration changes take effect after reboot. This is described in the AT Commands specification document - please see the parameter description for this command. The document does not specify the factory settings for this command. Your application should make sure that the desired settings are configured.
Regards,
Bartłomiej