Thales' cellular IoT products business is now part of Telit Cinterion, find out more.

You are here

Can't run midlet on the evaluation board (EHS6) | Telit Cinterion IoT Developer Community

November 5, 2014 - 3:04pm, 5983 views

Hi all,

Suddnely, after a week of working, the evaluation board is not working any more.

Every time i'm runing a midlet using the Eclipse I'm getting the following error:

Using USB port COM5.

Connecting to module...
Initializing module for debugging...
Enabling EHSx debug mode...
Waiting for EHSx module reset...
Establishing "IP connection for remote debugging of EHSx"...
Passing control to external device emulator...

The specified port is not open.

Establishment of TCP/IP connection failed!
Check the COM connection and dial up network parameters!

*** Error ***
Device "IMP_NG_EHS5_REMOTE1" not registered!

End of debug session. Emulator is closed!

This is the scfg data:

AT^SCFG?

^SCFG: "Call/ECC","0"
^SCFG: "GPRS/AutoAttach","enabled"
^SCFG: "Gpio/mode/ASC1","std"
^SCFG: "Gpio/mode/DAI","gpio"
^SCFG: "Gpio/mode/DCD0","std"
^SCFG: "Gpio/mode/DSR0","std"
^SCFG: "Gpio/mode/DTR0","std"
^SCFG: "Gpio/mode/FSR","gpio"
^SCFG: "Gpio/mode/HSIC","rsv"
^SCFG: "Gpio/mode/PULSE","gpio"
^SCFG: "Gpio/mode/PWM","gpio"
^SCFG: "Gpio/mode/RING0","std"
^SCFG: "Gpio/mode/SPI","rsv"
^SCFG: "Gpio/mode/SYNC","gpio"
^SCFG: "Ident/Manufacturer","Cinterion"
^SCFG: "Ident/Product","EHS6"
^SCFG: "MEShutdown/Fso","0"
^SCFG: "MEopMode/SoR","off"
^SCFG: "Radio/Band","511"
^SCFG: "Radio/OutputPowerReduction","4"
^SCFG: "Serial/Interface/Allocation","1","1"
^SCFG: "Serial/USB/DDD","0","0","0409","1E2D","0058","Cinterion Wireless Modules","EHx",""
^SCFG: "Tcp/IRT","3"
^SCFG: "Tcp/MR","10"
^SCFG: "Tcp/OT","6000"
^SCFG: "Tcp/WithURCs","on"
^SCFG: "Trace/Syslog/Otap","0"
^SCFG: "URC/Ringline","local"
^SCFG: "URC/Ringline/ActiveTime","2"
^SCFG: "Userware/Autostart","1"
^SCFG: "Userware/Autostart/Delay","0"
^SCFG: "Userware/DebugInterface","0.0.0.0","0.0.0.0","0"
^SCFG: "Userware/DebugMode","on"
^SCFG: "Userware/Passwd",
^SCFG: "Userware/Stdout","usb",,,,"off"
^SCFG: "Userware/Watchdog","0"

OK

Thanks in advance

Shaul