BGS5T restart after a few I2C read/write commands | Telit Cinterion IoT Developer Community
October 13, 2015 - 4:49pm, 3336 views
Hello,
I am using a ***127 ADC via I2C and I am able to communicate with it fine most of the time. However after a few read/writes the terminal reboots itself. Even when I enter at^sspi= manually and enter the proper commands one at a time and very slowly the terminal seems to randomly reboot.
I have the same problem when using I2cBusConnection with lots of delays. Everything works fine for a few cycles and then the terminal reboots without warning or errors.
I have 1K5 pull up risistors and don't have this problem with the TC65.
Any ideas as to what might be going on?
Some ***** right on the first command <a5080> the terminal reboots with no errors or messages.
I figured it out. Incorrect risistor value. Should be 2K2 Ohm!
Seems that problem is solved. I hope that it's working fine now with the correct resistor.