BGS2, AT Commands initial setup | Telit Cinterion IoT Developer Community
February 21, 2017 - 1:55pm, 2088 views
Dear colleagues, i am working on a project with BGS2 and i would like to know a typical initial sequence with AT Commands to set up this module before any connection or internet service action. Thank you for your support. Best regards.
Hello,
You need to enter the PIN with AT+CPIN command if needed or at least check the PIN status with AT+CPIN?. Then the module should register to the network. You can verify this with AT+COPS? or AT+CREG? commands. You can also verify the network parameters with AT^SMONI.
Regards,
Bartłomiej