bandwidth utilization on the EHS5 | Telit Cinterion IoT Developer Community
August 23, 2017 - 4:17am, 1516 views
Hello,
I was wondering if there is a command available to measure how many bytes have been sent/received from the ehs5 module. I am currently using the PPP to aquire the IP address etc.
thanks in advance,
Leonardo Orellano
Hello,
If you are using PPP then you could measure on the application side. There is no *****er and AT command to read it.
It is possible to read the sent and received data while using IP services over AT commands.
You will be able to ***** the bare data that you send and receive but this will not be the same as the data transfer that is *****ed and charged by the operator - it is only possible on the operator side.
Regards,
Bartłomiej