/etc/config/network | Telit Cinterion IoT Developer Community
September 20, 2017 - 11:41am, 17448 views
Hi,
I accidentally mess up the network file and now I'm not able to connect to the ehs6t-LAN modem. Is there a factory reset (will the factory reset back the network file)?
Or I able to connect via serial port through PC and using the some command to setup the network or reset via AT command can solve this?
Cheers
Feb 25 2021 - 2:06pm
Hi,
I have similar issue with my EHS6T-LAN REVISION 3.001. I could ping to 192.168.1.1 but I could not access to webserver. I also can't use most of AT commands. I send AT command but none respond came back. I would like to try factory reset. Please, could you send me tutorial how to do it?
Ondra
Hello,
Module is only used as a ****m in this solution and has no influence on OpenWrt system and LAN access to it. So there is no point in updating it's firmware if the module is working correctly - it replies to AT commands on ASC0 interface.
If you are unable to force the terminal to switch to a firmware flashing **** on LAN maybe you could try to connect to it on the previously set IP with a manual configuration on the PC side also. If nothing works you may need to contact your distributor.
Regards,
Bartłomiej
Hey, We accidentaly switched the network to vlan and we are not able to connect to 192.168.1.1. please help to reset to factory defaults Our modem is ELS61T E2
Thanks,
Mihai
Hello,
Is there any way to connect to it, on any IP that you reconfigured? The reset procedure is in fact the procedure to install the firmware image again.
Regards,
Bartłomiej