EHS5T RS485 writes gibberish on the serial prot ASC1 | Thales IoT Developer Community
November 29, 2018 - 8:11am, 3234 views
The "EHS5T RS485" writes gibberish on the port without any user Software on it.
I connected a display to it, and after restarting the box it writes "y5e" on the output, and the longer I keep it connected the more characters appear on the display.
I was able to measure the signal with an oscilloscope, and it looks like propper/intended serial communication
I use a 4 wire connection for the display (RX, TX, Vcc and GND)
I connected a "virgin" Module out of the box to the display. I didn't change anything about the configuration. There is also no user software on it.
Any idea how to turn that off, or is a Firmware update planned to fix that?