Thales' cellular IoT products business is now part of Telit Cinterion, find out more.

You are here

Community > Forum > Cellular Hardware > TC65i rev. 02.004 network registration problem

TC65i rev. 02.004 network registration problem | Telit Cinterion IoT Developer Community

Like
0
3
Alessio Sambarino's picture
Alessio Sambarino

February 20, 2017 - 10:47am, 2612 views

I used many thousands of TC65i rev 01.100 without problems, now I need to use TC65i rev 02.004 (A-REVISION 03.000.20). I replaced the module with the new one but it doesn't register to the network (+CREG: 0,0).

Is it necessary to enable some feature by AT commands?

3
Comment
Log in or register to post comments
Bartłomiej Gemalto Moderator's picture
Bartłomiej Gema...
Feb 20 2017 - 5:48pm

Hello,

Is the CREG 0,0 after restart also - that would mean that it is not searching for the network. Maybe it is in the airplane mode. Please check AT^SCFG? output - maybe there's the answer.

Regards,

Bartłomiej

Alessio Sambarino's picture
Alessio Sambarino
Feb 22 2017 - 8:30am

Hello,

I solved the problem, the module ***** to receive AT+COPS=0, otherwise it doesn't find the network.

Thanks,

Alessio.

Bartłomiej Gemalto Moderator's picture
Bartłomiej Gema...
Feb 22 2017 - 10:46am

Hello,

This command chooses the automatic network selection.

Is it needed each time after booting? If so maybe the manual network selection was configured in the past and stored to the user profile which is restored after each boot.

Maybe you should try to restore the factory settings and then store to the user profile. Please check the commands AT&F, AT&V, AT&W.

Regards,

Bartłomiej