IMP Debug Connection fails | Telit Cinterion IoT Developer Community
December 28, 2016 - 7:34am, 5961 views
Hello,
I have BGS5 module on our own pcb board. I can send at commands via USB0 and can access ffs using MES via USB0 but cannot use IMP Debug Connection on eclipse via USB0.
Why can it be? Is there a setting or configuration to be able to use IMP Debug?
Best Regards,
Hello Ergun,
These lines are needed for debugging on all interfaces. I suppose that it is so from the historical reasons - this feature was initially implemented for the modules that did not have USB interface.
ASC1 is not recommended because it does not have these lines and the DCD0 line ***** to be electrically set to high for debugging over ASC1 and the missing DTR input on ASC1 may cause that in some cases the module has to be reset manually.
For performance reasons USB is the recommended interface.
Best regards,
Bartłomiej
Ok Bartlomiej,
Thank you very much.
Best Regards,
Ergün.