Thales' cellular IoT products business is now part of Telit Cinterion, find out more.

You are here

EHS6T - USB Serial Port dies after AT+CFUN=1,1 | Telit Cinterion IoT Developer Community

April 1, 2015 - 12:07pm, 5367 views

If I issue an AT+CFUN=1,1 (soft reset) command to an EHS6T modem the connected USB serial port is dropped and I can not open the serial port again with out a power cycle of the EHS6T (hard reset).

Is this normal behavior for the USB serial port interface on the EHS6T modem ?

I get an OK answer from the AT+CFUN=1,1 but after that the modem does not respond to AT commands and there is no ^SYSSTART shown.

If I issue an AT+CFUN=0 (shutdown) I get the OK and ^SHUTDOWN shown fine.

It seems like the AT+CFUN=1,1 is not working properly.

I have firmware revision: